• Welcome to https://albinowners.net, home of Albin Owners Group!
• If you don't remember your password, use the I forgot my password link to reset it.
• Contact Us if you have any questions. If you're not receiving our email, include a phone number where we can text you.
• If you don't remember your password, use the I forgot my password link to reset it.
• Contact Us if you have any questions. If you're not receiving our email, include a phone number where we can text you.
FAQ:
• Membership information
• Burgees
• How to post photos
• Membership information
• Burgees
• How to post photos
94 Albin 28TE Windlass
-
Foolishfrog7
- Swabby
- Posts: 1
- Joined: Fri Feb 07, 2014 8:44 pm
- Home Port: New Rochelle
94 Albin 28TE Windlass
Fellow members on this site have stated that the Albin 28TE is pre-wired for windlass. I have a 94 and can not seem to find the wires in the anchor locker. Was this standard on a 94 and if so where are the wires located? Any help or information is greatly appreciated!!!
-
Serenity
- In Memorium
- Posts: 598
- Joined: Mon Dec 13, 2010 12:15 pm
- Home Port: East Islip Anglers, New York
- Location: Long Island
Re: 94 Albin 28TE Windlass
I would look under the port side V-berth or take a peak under the aft berth on the forward bulkhead. Don't get confused with the bow thruster harness.
Max
Serenity 98 28TE
East Islip, Long Island, New York
Serenity 98 28TE
East Islip, Long Island, New York
-
thomaslong
- Gold Member
- Posts: 98
- Joined: Wed Sep 19, 2012 3:08 pm
- Home Port: New Orleans
Re: 94 Albin 28TE Windlass
I just installed a windlass in my 1996 Albin 28 TE, and there was no existing wiring. All new wiring had to be run from the windlass back to the bus, switch and breaker down the starboard side, following the same route as the thruster wiring.